Next steps for Box
Today, we are going to continue our box:
1. Sand down the rebate joints. Sand down sawed edges.
2. Take the shorter larger piece (9 cm), and put it in one of the two rebate joints. Take 2 nails and nail them on the sides of the thin rebate joint side. Then, take the small (8cm) piece, cut off 5mm-1cm of the top, add glue on one side and nail it to the other side of the long board with the other short piece.
3. Finally, take the other rebate joint long piece and glue and nail it to the rest of the box, making sure that the rebate side is on the longer shorter (9cm) piece of wood.
4. Sand down the box, and oil it down.
5. Cut a base made out of plywood, 3mm- 5mm thick, and measure the contour of your box with it to get the right size.
#2
#3
#1
You're done!